Hafm Application; Drive; Server - HP StorageWorks 2/140 - Director Switch Release Note

Installing HAFM on an Existing EFCM or SDCM Server
Installation of HAFM on an existing EFCM or SDCM server will successfully
migrate the older data files into the new configuration. Refer to the HP
StorageWorks Director FC-64 to Director 2/64 Upgrade Instructions,
A6574-96003/AA-RSS1A-TE or HP StorageWorks Director 64 to Director 2/64
Upgrade Instructions, AA-RT4JA-TE.
Replacing CD-ROM with ZIP Drive
The CD-ROM should be installed in the HAFM server only for loading and
configuring the HAFM software, or for adding new director or edge switch
firmware to the HAFM Firmware libraries. The CD-ROM should be replaced with
the ZIP drive module for normal operation of the HAFM to allow for ZIP drive
backups of the SAN configuration information.
Losing LAN Connection to the HAFM Server Before Logging in to the

HAFM Application

If the LAN connection to the HAFM server is lost before logging on to the HAFM
application, you cannot log in to the application. If the LAN connection to the
HAFM server is lost while the HAFM application is running, the application will
stop and the following error message displays "Connection to the HAFM
server lost. Click OK to exit the application."
Workaround
The LAN connection must be restored, and the HAFM server must be rebooted to
restore normal HAFM operation. Neither stopping the HAFM application nor
rebooting the server has any impact on the Fibre Channel operations of any switch
or director. Only monitoring switch operations, logging events, and implementing
configuration changes are interrupted.
HA-Fabric Manager Release Notes
Known Issues
9