Input Mode Read Command; Lamp Time Read Command; Setting Read Command - Sanyo PLV-WF20 - 6000 Lumens Manual

PLV-WF20 Basic Serial Command Functional Specifications
7.4

Input Mode Read Command

COMMAND "CR1" [CR]
Detail Get currently selected SLOT
Acceptable
Response
Unacceptable
7.5

Lamp Time Read Command

COMMAND "CR3" [CR]
Detail Get total lamp running hours
Acceptable
Response
Unacceptable
7.6

Setting Read Command

COMMAND "CR4" [CR]
Detail Get screen setting status of Ceiling/Rear.
Acceptable
Response
Unacceptable
"%1" [CR]
"1" = Input 1 is selected
"2" = Input 2 is selected
%1 "3" = Input 3 is selected
"4" = Input 4 is selected
(In the case SLOT method, SLOT 1~4 is selected.)
"?" [CR]
"%1_%2" [CR]
Each lamp data follows in sequence with one space between
each of them.
%1 = lamp No.1
%2 = lamp No.2
ex; "0410_0410_0410_0410" [CR]
%1, %2
▪▪▪▪ → Lamp No.1 = 410 Hours
Lamp No.2 = 410 Hours
Note;
-each data shall be 4 digits.
-"9999" is returned for 10000 hours or more.
"?" [CR]
"%1" [CR]
"11" [CR] = Normal Screen Setting
"10" [CR] = Picture is top/bottom reversed
(Status: Rear & Ceiling ON)
%1
"01" [CR] = Picture is left/right reversed (Status: Rear ON)
"00" [CR] = Picture is top/bottom and left/right reversed
(Status: Ceiling ON
"?" [CR]
)
19/24