HP StorageWorks 12000 - Virtual Library System EVA Gateway Manual page 79
Hp storageworks vls and d2d solutions guide (ag306-96028, march 2010)
Hide thumbs
Also See for StorageWorks 12000 - Virtual Library System EVA Gateway:
- User manual (266 pages) ,
- Design manual (160 pages) ,
- Release note (13 pages)
Table of Contents
Advertisement
1.
Start the replication wizard.
a.
Select the Replication tab in D2D GUI and then the Mapping Configuration tab. The wizard
can then be initiated. All the configuration talks place on the source library. The only actions
necessary on the target library are to configure it with an IP address. Note also that this is
the starting point for the recovery wizard. Library 1 is the new source library in the D2D2500.
Notice how the source library is initially "non-replicating" until it becomes part of a replication
pair.
b.
Select Start Replication Wizard.
2.
Add a target device to source device.
a.
Using the D2D replication wizard you can set the IP address of the target library device.
You must know the target library IP address. In this case, 192.168.0.207.
b.
Input the target appliance IP address.
c.
Select Add Target Appliance.
The target library appears to the source and is online.
HP StorageWorks VLS and D2D Solutions Guide
79
Advertisement
Table of Contents
