Example Schematic - HP StorageWorks 12000 - Virtual Library System EVA Gateway Manual

Configuring Replication
The following steps will configure D2D replication.
If using tape initialization, the initialization process has to happen before the replication is configured.
Prior to configuring replication, you must enter the replication license on the target device.
Use the diagram below when reviewing the steps to configuring replication. This example uses a
D2D2500 source library IP 192.168.0.44 and a D2D4000 Fibre Channel target library at
192.168.0.207. The target already has another source mapped into it from D2D4000 at
192.168.0.43.
All the network parameters must be set correctly before starting the replication configuration. The IP
addresses are set as part of the initial D2D installation using either a "Discovery CD" or by connecting
a monitor and keyboard to the rear of the D2D unit. You must set your DNS and gateway address.
DHCP is permitted but the network administrator should ensure that there is a permanent lease assigned.
Figure 31 Example Schematic
.
78 D2D Systems