HP P6000 Replacement Instructions page 3

8. Separate the drive cage from the chassis.
a. Disconnect all cables from the backplane.
b.
On each side of the chassis, remove the three T-10 screws that
secure the drive cage to the chassis.
c. Grasp the top of the drive cage, slide it off the guideposts on
the bottom of the chassis, and lift the drive cage just out of the
chassis.
9. Remove the front UID.
a. Remove the T-10 screw securing the bezel to the chassis ear
and let the black bezel separate from the ear.
b. Remove the T-10 screw securing the interconnect board to the
bezel and lift the interconnect board away from the bezel.
c. Remove the piece of tape securing the cable to the drive cage.
d. Disconnect the cable from the interconnect board.
Installing the power UID interconnect
board
1. Secure the power UID interconnect board.
a. Connect the replacement cable to the replacement interconnect
board.
b. Secure the interconnect board to the bezel with the T-10 screw.
c. Secure the cable to the drive cage with the provided strip of
tape.
d.
Secure the bezel to the chassis ear with a T-10 screw.
Page 3