HP P6000 Installation Instructions Manual page 14

Figure 13 Adding a disk enclosure below the P6500 EVA
Table 3 Adding a disk enclosure below the P6500 EVA callouts
Callout
1
2
3
4
3. Using a cable provided in your kit, plug one end into the P1 port of I/O module A (below the
controller enclosure) that was unplugged in the previous step and plug the other end into port P2
of I/O module A of the newly installed disk enclosure (2,
4. Complete the connections to I/O module B of the newly installed disk enclosure (below the
controller enclosure). The result is the DP- 1 cable on port P1 of I/O module B of the disk enclosure
previously closest to the controller enclosure is moved to port P1 of I/O module B of the newly
installed disk enclosure (3,
P1 of the existing disk enclosure and I/O module B port P2 of the newly installed disk enclosure
(4, Figure
5. Follow steps 8–14 in
the installation.
14 Cabling the enclosure
Description
Connects installed I/O module A, port P1 (below controller) to controller 1, port DP-A (using the DP- 1
cable)
Connects installed I/O module A, port P2 (below controller) to existing I/O module, port P1
Connects installed I/O module B, port P1 (below controller) to controller 2, port DP-B (using the DP- 1
cable)
Connects installed I/O module B, port P2 (below controller) to existing I/O module B, port P1
Figure
13).
"Cabling the P6300 EVA enclosure while offline" (page 8)
13). Also, a new cable is installed between I/O module B port
Figure 13).
to complete