Asus P8H61-M LX2 R2.0 User Manual page 34

6. Intel H61 Serial ATA 3.0Gb/s connectors (7-pin SATA3G_1~4)
®
These connectors connect to Serial ATA 3.0 Gb/s hard disk drives and optical drives via
Serial ATA 3.0 Gb/s signal cables.
P8H61-M LX2 R2.0
P8H61-M LX2 R2.0 SATA connectors
• You must install Windows
• Due to H61 Chipset limitation, AHCI Mode only works on Windows
• [IDE] is the default SATA type. Under Windows
• To configure the SATA type in BIOS, click Advanced Mode > Advanced tab > SATA
• When using hot-plug and NCQ on Windows
7. Digital audio connector (4-1 pin SPDIF_OUT)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port. Connect
the S/PDIF Out module cable to this connector, then install the module to a slot
opening at the back of the system chassis.
P8H61-M LX2 R2.0
P8H61-M LX2 R2.0 Digital audio connector
The S/PDIF module is purchased separately.
1-24
RSATA_TXP1
RSATA_TXN1
RSATA_RXN1
RSATA_RXP1
RSATA_TXP2
RSATA_TXN2
RSATA_RXN2
RSATA_RXP2
hard disk drives.
Please use IDE Mode on Windows
SATA type.
Configuration > SATA Mode Selection.
item in the BIOS to [AHCI Mode]. See section 2.5.4 SATA Configuration for details.
SPDIF_OUT
SATA3G_1 SATA3G_3
GND
GND
GND
SATA3G_2 SATA3G_4
GND
GND
GND
XP Service Pack 3 or a later version before using Serial ATA
®
XP.
®
®
Vista / Windows
®
Vista / Windows
®
XP, there is no need to change the
7, set the SATA Mode
®
ASUS P8H61-M LX2 R2.0
7.
®