Advertisement
Example 6: EPSR with an iMAP
This example is the same as
three switches is an iMAP. We used an AT-TN7100 iMAP running 6.1.10. The ring ports on
the iMAP are 5.0 and 5.1. The example first shows the configuration script for the iMAP as
the master node, then as the transit node. For the configuration of the other two switches,
see Example 1.
Configure the AT -TN7100 iMAP as Master Node
The following diagram shows a partial script for the iMAP, with the commands for configuring
it as a EPSR master node and other relevant commands.
ADD IP INTERFACE=MGMT IPADDRESS=172.28.9.3 SUBNETMASK=255.255.255.0
CARD=ACTCFC GATEWAY=172.28.9.1
#
SET SWITCH AGEINGTIMER=300
#
SET SYSTEM PROVMODE=AUTO
SET SYSTEM GATEWAY=172.28.9.1
#
CREATE EPSR=test MASTER HELLOTIME=1 FAILOVERTIME=2 RINGFLAPTIME=0
#
CREATE VLAN=vlan2 VID=2 FORWARDINGMODE=STD
CREATE VLAN=vlan1000 VID=1000 FORWARDINGMODE=STD
#
ADD VLAN=2 INTERFACE=ETH:[5.0-1] FRAME=TAGGED
ADD VLAN=1000 INTERFACE=ETH:[5.0-1] FRAME=TAGGED
#
DELETE VLAN=1 INTERFACE=ETH:[5.0-1]
#
SET INTERFACE=ETH:[5.0-1] ACCEPTABLE=VLAN
#
ADD EPSR=test INTERFACE=ETH:[5.0] TYPE=PRIMARY
ADD EPSR=test INTERFACE=ETH:[5.1] TYPE=SECONDARY
ADD EPSR=test VLAN=1000 TYPE=CONTROL
ADD EPSR=test VLAN=2 TYPE=DATA
#
ENABLE EPSR=test
Page 26 | AlliedWare™ OS How To Note: EPSR
"Example 1: A Basic Ring" on page 11
Example 6: EPSR with an iMAP
except that one of the
Advertisement
