Advertisement
•
•
•
•
Next, it discusses important implementation details in the following sections:
•
•
•
•
Finally, it ends with troubleshooting information in the following sections:
•
•
•
•
Which products and software versions does it
apply to?
This How To Note applies to the following Allied Telesis switches:
•
•
EPSR is also available on the following Allied Telesis switches, running the AlliedWare Plus OS
software version 5.2.1 or later:
•
•
For information about using the AlliedWare Plus OS, see the AlliedWare Plus Note, How To
Configure EPSR (Ethernet Protection Switching Ring) to Protect a Ring from Loops. This Note is
available from
The implementation on the above switches is also compatible with EPSR on Allied
Telesis'
Page 2 | AlliedWare™ OS How To Note: EPSR
"Example 3: EPSR and RSTP" on page 17
"Example 4: EPSR with Nested VLANs" on page 20
"Example 5: EPSR with management stacking" on page 23
"Example 6: EPSR with an iMAP" on page 26
"Classifiers and Hardware Filters" on page 29
"Ports and Recovery Times" on page 30
"IGMP Snooping and Recovery Times" on page 31
"Health Message Priority" on page 31
"EPSR State and Settings" on page 32
"SNMP Traps" on page 34
"Counters" on page 35
"Debugging" on page 36
AT-8948, x900-48FE, x900-48FE-N, AT-9924T, AT-9924SP, and AT-9924T/4SP switches,
running software version 2.8.1 or later
AT-9924Ts, x900-24XT, and x900-24XT-N switches running software version 3.1.1 or
later
SwitchBlade x908
x900 series
www.alliedtelesis.com/resources/literature/howto_plus.aspx.
Multiservice Access Platforms
Which products and software versions does it apply to?
(iMAPs).
Advertisement
