2.
Primary IDE connector (40-1 pin PRI_IDE [blue])
The onboard IDE connector is for an Ultra DMA 133/100/66 signal cable.
There are three connectors on each Ultra DMA 133/100/66 signal cable:
blue, black, and gray. Connect the blue connector to the motherboard's IDE
connector, then select one of the following modes to configure your device(s).
®
P5VD2-VM SE
P5VD2-VM SE IDE connector
Single device
Two devices
•
Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
•
Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
ASUS P5VD2-VM SE
PIN1
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
PRI_IDE
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
Mode of
device(s)
-
Master
Slave
Master
Slave
Cable connector
Black
Black
Gray
Black or gray
1-29