Jumper Settings - Asus P5N32-SLI-Deluxe User Manual

2 . 2 . 2 . 2 . I D E c o n n e c t o r s I D E c o n n e c t o r s I D E c o n n e c t o r s
2 . I D E c o n n e c t o r s I D E c o n n e c t o r s
( 4 0 - 1 p i n P R I _ I D E , S E C _ I D E ) ( 4 0 - 1 p i n P R I _ I D E , S E C _ I D E ) ( 4 0 - 1 p i n P R I _ I D E , S E C _ I D E )
( 4 0 - 1 p i n P R I _ I D E , S E C _ I D E ) ( 4 0 - 1 p i n P R I _ I D E , S E C _ I D E )
These connectors are for Ultra DMA 133/100/66 signal cables. The
Ultra DMA 133/100/66 signal cable has three connectors: a blue
connector for the primary IDE connector on the motherboard, a black
connector for an Ultra DMA 133/100/66 IDE slave device (optical
drive/hard disk drive), and a gray connector for an Ultra DMA 133/
100/66 IDE master device (hard disk drive). If you install two hard disk
drives, you must configure the second drive as a slave device by setting
its jumper accordingly. Refer to the hard disk documentation for the

jumper settings.

• Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.
• These connectors support RAID 0, RAID 1, RAID 0+1, RAID 5 and
JBOD that spans across the Serial ATA drives.
®
P5N32-SLI IDE connectors
A S U S P 5 N 3 2 - S L I D e l u x e A S U S P 5 N 3 2 - S L I D e l u x e
A S U S P 5 N 3 2 - S L I D e l u x e A S U S P 5 N 3 2 - S L I D e l u x e A S U S P 5 N 3 2 - S L I D e l u x e
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PIN 1
2 - 3 1 2 - 3 1
2 - 3 1 2 - 3 1 2 - 3 1