Asus P5KC Installation Manual page 57

4. JMicron JMB363
This connector is for a Serial ATA signal cable that supports a Serial ATA hard
disk drive. To configure RAID 0, RAID 1, or JBOD, install an internal Serial
ATA hard disk drive to this connector and an external Serial ATA drive to the
external SATA port.
The JMicron controller mode item in the BIOS is set to [IDE] by default. Setting
this item to [RAID] allows you to use the connectors to build a RAID set. See
section 5.4.3 JMicron
[AHCI] supports Native Command Queuing (NCQ) function. See section 4.4.5
Onboard Devices Configuration for details.
P5KC
P5KC SATA connector
Before creating a RAID set using Serial ATA hard disks, make sure that you
have connected the Serial ATA signal cables and installed Serial ATA hard disk
drives; otherwise, you cannot enter the JMicron
BIOS setup during POST.
ASUS P5KC
Serial ATA RAID connector (7-pin SATA_E2)
®
RAID Configuration for details. Setting this item to
®
®
SATA_E2
JMB363 RAID utility and SATA
®
2-33