Panasonic WV-SW175 Operating Instructions Manual page 109

When the brightness (illuminance) level on the screen is set to a relatively low level with the [Brightness]
buttons, flickering may frequently happen.
•
When the setting for "Light control mode" is "Indoor scene (50 Hz)", "Indoor scene (60 Hz)" or "ELC"
whose maximum exposure time is 1/2000s or longer, brightness may not be remarkably changed even
when [Brightness] buttons are clicked.
•
In such cases, either of the following can reduce flickering.
–
Moderate the illumination intensities of objects by changing the camera direction.
–
Set the brightness (illuminance) level on the screen to a brighter level with the [Brightness] buttons.
•
When "On" is selected for "Wide dynamic range (WDR)", only "Indoor scene (50 Hz)", "Indoor scene
(60 Hz)" and "ELC(1/30s)" are available.
[AGC]
Select a method of gain adjustment from the following.
•
On(High)/On(Mid)/On(Low): When the luminance of the subject becomes darker, gain will be
automatically incremented and screen will become brighter. "High", "Mid" and "Low" are indications of gain
level.
•
Off: Images will be captured with the fixed gain level.
•
Default: On(High)
[Auto slow shutter]
The electronic sensitivity enhancement (sensitivity up) can be carried out by adjusting the storage time of the
sensor.
The following are available for the recording duration.
Off(1/30s), Max.2/30s, Max.4/30s, Max.6/30s, Max.10/30s, Max.16/30s
•
Default: Off(1/30s)
IMPORTANT
•
When "On" is selected for "Auto slow shutter", frame rate may become lower. Noise or white dots
(blemishes) may sometimes appear.
Note
•
When "Max. 16/30s" is selected, for example, sensitivity will automatically be increased up to x16.
When "Off" is selected for "AGC", this setting is unavailable.
SW175 SW175 SW174W SW174W
•
When "Off" is selected for "AGC", "Off(1/30s)" will be set for "Auto slow shutter".
[Day & Night(electrical)]
Select switching between the color mode and the black & white mode from the following.
•
Off: The color mode is selected.
•
Auto: Switches from color to black-and-white images when the ambient brightness (illuminance) of the
camera is approx. 1.0 lx or less
less
SW172 SW172 ST162 ST162
•
Default: Off
[White balance]
Select a method of white balance adjustment from the following.
White color can be adjusted by "Red gain" and "Blue gain".
•
ATW1: Selects the automatic tracing white balance mode. The camera will constantly check the color
temperature of the light source and adjust the white balance automatically. Operating color temperature
range is approx. 2,700 K - 6,000 K.
11 Configure the settings relating to images and audio [Image/Audio]
SW172 SW172 ST165 ST165 ST162 ST162
/approx. 4 lx or less
SC384 SC384
. It takes time to switch between modes.
:
SW175 SW175
/approx. 2 lx or
SW174W SW174W ST165 ST165
Operating Instructions 109