Clear Cmos Jumper - Gigabyte GA-Q77M-D2H User Manual

15) DEBUG PORT (Debug Card Header)
This header can connect a debug card.
16) CLR_CMOS (Clear CMOS Jumper)
Use this jumper to clear the CMOS values (e.g. date information and BIOS configurations) and reset the
CMOS values to factory defaults. To clear the CMOS values, use a metal object like a screwdriver to touch
the two pins for a few seconds.
• Always turn off your computer and unplug the power cord from the power outlet before clearing
the CMOS values.
• After system restart, go to BIOS Setup to load factory defaults (select Load Optimized Defaults) or
manually configure the BIOS settings (refer to Chapter 2, "BIOS Setup," for BIOS configurations).
(Note) Whether this feature is supported depends on the product being received.
(Note)
Pin No. Definition
1
1
11
2
3
4
12 2 5
6
7
8
9
10
11
12
Open: Normal
Short: Clear CMOS Values
- 23 -
No Pin
GND
VCC3
LAD0
LAD1
LAD2
LAD3
-LFRAME
-PFMRST
DB CLK
DB_P_SENSOR
NC