Table of Contents
Advertisement
AOC-SG-i2 Add On Card User's Guide
2-2
Front Connectors, Jumpers and LEDs
This section describes the front connectors, jumpers and LEDs found on the AOC-SG-i2
add-on card.
LAN Ports
LAN ports allow the add-on card to connect to a maximum of four network cables. These
are RJ45 connectors. Each LAN port provides up to one gigabit per second connection
speed which require CAT6 cables for maximum throughput.
The ports are designated LAN1, LAN2, LAN3 and LAN4.
LAN Port LEDs
Each LAN port includes two LEDs. The LEDs indicate connection speed and activity.
See
Table 2-2
for definitions of these LEDs.
LED
Color
Act
Amber (blinking)
Orange
LNK
Green
Off
Front Jumpers and Pin Definitions
To modify the operation of the add-on card,
jumpers are used to choose between optional
settings.
Jumpers create shorts between two pins to
change the function of the connector. Pin 1 is
identified with a square pad on the printed
circuit board.
On two pin jumpers, "Closed" means the
jumper is on and "Open" means the jumper is
off the pins.
When properly configured, this add-on card allows Network Administrators to use STBY
enabled and STBY disabled settings. In addition to configurations required by your
motherboard and software, you must close the J2 jumper on the add-on card to enable
this feature.
Table 2-2. LAN Port LEDs
Definition
LAN Activity
Link speed in Kb/s
Link speed in 100 Mb/s
No connection or link speed at 10 Kb/s
2-2
3
2
1
Connector
Pins
Jumper
3
2
1
Setting
Advertisement
Table of Contents
