Synology DiskStation DS3612xs Quick Installation Manual page 12

4 Insert the new memory module in the memory slot on the motherboard:
a Open the ejectors on the memory slot and push them out to the sides.
b Align the notch on the gold edge of the module with the notch in the memory slot.
c Use two fingers with firm, even pressure to push down on the memory module.
d When the memory is inserted correctly, the ejectors will snap into place.
Important: Hold the memory module by its edges, and do not touch the gold connectors.
5 Connect the 5 cables you disconnected in step 3, replace the inner panel, and tighten the 6 screws to secure it.
6 Replace the top and side cover, and tighten the screws you removed in step 2.
Make Sure DiskStation Recognizes the New Memory Capacity
After installing the memory module on DiskStation, it's recommended that you check whether the server
recognizes the new memory.
To check the memory of your DiskStation:
1 Start up your DiskStation. (See "Start Up Your DiskStation" on Page 10 for more information.)
2 Install DSM. (See "Chapter 3: Install DSM on DiskStation" on Page 15 for more information.)
3 Log in to Synology DiskStation Manager (DSM).
4 Check Total Physical Memory
If your DiskStation doesn't recognize the memory or doesn't start up correctly, check out if the memory is
installed correctly.
12 Chapter 2: Hardware Setup
Main Menu System Information.
in >
DiskStation
DS3612xs
4096 MB