Events - Axis M1014 User Manual

AXIS M1014 Network Camera

Events

Events
The Axis product can be configured to perform actions when different events occur, for example, start a recording when motion is
detected. The set of conditions that defines how and when the action is triggered is called an Action Rule.
Available Action Rule triggers and conditions include:
Detectors
•
- Motion Detection — trigger the rule when motion is detected, see
Tampering — trigger the rule when tampering is detected, see
-
• Hardware
Network — trigger the rule if network connection is lost or restored. This can for example be used to start
-
recording to the SD card.
Input Signal
•
Manual Trigger — trigger the rule using the Manual Trigger button in the Live View page, see
-
Live View Page, on page 8
and configuration.
PTZ
•
Moving — trigger the rule when the camera view moves due to a PTZ operation. This can for example be used
-
as an additional condition to prevent an action rule triggered by motion detection to record video while the
camera view moves due to a PTZ operation.
- Preset Reached — trigger the rule when the camera stops at a preset position. This can be for example be used
with the Send Images action to upload images from the preset position.
• Storage
Available — trigger the rule when the storage device is unmounted or removed. This can for example be
-
used to send maintenance notifications.
Full — trigger the rule when the storage device is full. Under normal operation, the oldest recordings will be
-
overwritten to prevent the storage device from becoming full.
Locked — trigger the rule if the storage device is locked (write protected).
-
System
•
System Initializing — trigger the rule when the product is being started. This can for example be used to send a
-
notification when the product restarts.
Time
•
Recurrence — trigger the rule periodically, see
-
upload an image every 5 minutes.
Use Schedule — trigger the rule according to the selected schedule, see
-
Available actions include:
PTZ Control
•
Preset Position — go to a preset position.
-
Guard Tour — start a guard tour, see
-
Record Video — record video to a selected storage.
•
. This can for example be used to validate actions during product installation
Recurrences, on page 28
Guard Tour, on page 21
26
Motion Detection, on page 23
Camera Tampering, on page 23
. This can for example be used to
Schedules, on page 28
.
.
.
Controls on the
.