Hardware Overview; Led Indicators - Axis M3114-VE User Manual

AXIS M3114-VE Network Camera

Hardware overview

Caution
Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded
network cable (STP) may be appropriate or required. Any network cables that are routed in outdoor environments or similar
shall be shielded (STP) and intended for their specific use. Make sure that the network switch is properly grounded. See
Electromagnetic Compatibility (EMC) for regulatory requirements.
Control button - The control button is used for:
• Connecting to an AXIS Video Hosting System service. See page 34. To connect, press and hold the button for about
1 second until the Status LED flashes green.
• Connecting to AXIS Internet Dynamic DNS Service. See page 35. To connect, press and hold the button for
about 3 seconds.
• Resetting the product to factory default settings. See page 40.

LED indicators

LED Color
Network Green
Amber
Unlit
Status Green
Amber
Red
Power Green
Amber
Note
• The Status LED can be configured to be unlit during normal operation. To configure, go to Setup > System Options >LED.
See the online help for more information.
• The Status LED can be configured to flash while an event is active.
• The Status LED can be configured to flash for identifying the unit. This can be done under Setup > System Options >
Maintenance.
Indication
Steady for connection to a 100 MBit/s network. Flashes for network activity.
Steady for connection to a 10 MBit/s network. Flashes for network activity.
No network connection.
Steady green for normal operation.
Steady during startup and when restoring settings.
Slow flash for failed upgrade.
Normal operation.
Flashes green/amber during firmware upgrade.
5