Installing R50Le, R90Le, R90Lew, Or R90Le7 Cloud Client Flash - Wyse C90LEW Installation Manual

8
Chapter 3

Installing R50LE, R90LE, R90LEW, or R90LE7 Cloud Client Flash

1. Perform a proper shutdown of the cloud client by closing all files and ending your
session, and then press the power button to turn off the cloud client.
2. Unplug the power cord and power adapter, remove all of the cables from the rear of the
cloud client, and detach the vertical foot.
3. Position the cloud client horizontally, and then remove the screws from the left side
cover of the cloud client using a small Phillips screwdriver as shown in Figure 5.
Figure 5 Removing the left side cover screws
4. Slide the left side cover toward the rear of the device and remove it to expose the main
board as shown in Figure 6. Notice that the rear of the cloud client is positioned at the
bottom of the photo.
5. To have easy access to the flash module, the PCI-e riser card must be removed first.
Using the finger tab, pull the card out of its connector and set aside.
Figure 6 Removing the PCI-e riser card
Caution
Follow all precautions listed in the Quick-Start Guide that came with your
cloud client for disconnecting and reconnecting the cloud client.
Warning
Flash modules may be susceptible to damage by Electro-Static Discharge
(ESD). All industry-standard cautions should be followed to avoid ESD.
Before you remove or install a module, touch any metal part of the chassis
and keep that contact with the chassis during the installation process.