Adjusting The Display Brightness; Maintaining; Troubleshooting - Insignia NS-R2001 User Manual

Insignia NS-R2001 AM/FM Stereo Receiver

Adjusting the display brightness

To adjust the display brightness:
• Press the DIMMER button to set the brightness of
the display.
Each time this button is pressed, the brightness
changes as follows:
• ON
• Dim
• OFF
Note
If the display is off, pressing any button turns the
display on.

Maintaining

To clean this receiver, wipe with a soft, dry cloth. If
the surfaces are extremely dirty, use a soft cloth
dipped in a soap and water solution or a weak
detergent solution.
• Never use alcohol, paint thinner, or benzine to
clean this receiver.
• Before using a chemically treated cloth, read the
instructions that came with the cloth carefully.

Troubleshooting

If a problem occurs, run through the table below
before contacting Insignia.
If the problem persists, attempt to solve it by
switching the receiver off and on again. If this fails
to resolve the problem, contact Insignia. Under no
circumstances should you attempt to repair the
receiver yourself as this could void the warranty.
Category
No power.
No sound.
Stations cannot
be received.
Preset stations
cannot be
received.
Poor FM
reception.
Continuous
hissing noise
during FM
reception,
especially
when a stereo
broadcast is
received.
Continuous or
intermittent
hissing noise
during AM
reception,
especially at
night.
www.insigniaproducts.com
Problem Possible Solution
• The AC power cord is • Connect the cord securely.
disconnected. • Check the outlet using a lamp or
• Poor connection at AC wall another appliance.
outlet or the outlet is
inactive.
• The speaker cords are loose • Check the speaker connections.
or disconnected. • Adjust the volume.
• The volume is adjusted too • Press the MUTE button to cancel the
low. muting effect.
• The MUTE button on the • Turn on one or both speakers.
remote control is pressed to • Select the desired input source
ON. correctly.
• Speakers are not switched • Make connections correctly.
on. • Press SPEAKER A or B to select the
• Incorrect selection of the correct speakers.
input source.
• Incorrect connections
between the components.
• The correct speaker is not
selected.
• No antenna is connected. • Connect an antenna.
• The desired station • Tune in the desired station
frequency is not tuned in. frequency.
• The antenna is in wrong • Move the antenna and retry tuning.
position.
• An incorrect station • Memorize the correct station
frequency has been frequency.
memorized. • Memorize the stations again.
• The memorized stations are • Connect an antenna.
cleared. • Change the position of the
• No antenna is connected. • antenna.
• The antenna is not • Press TUNE/PRESET until the
positioned for the best PRESET indicator lights.
reception.
• The receiver is not in
PRESET mode.
• No antenna is connected. • Connect an antenna.
• The antenna is not • Change the position of the antenna.
positioned for the best • Make sure the antenna is properly
reception. secured.
• The antenna connection • Make sure you are tuned to the
may not to secure. correct frequency.
• You may not be fully tuned • Try using an outdoor antenna.
to the correct frequency.
• Weak signals. • Change the position of the antenna.
• The antenna connection • Install an outdoor FM antenna.
may not to secure. • Make sure the antenna is properly
• You may not be fully tuned secured.
to the correct frequency. • Make sure you are tuned to the
• The receiver may be too correct frequency.
close to a TV or another • Move the devices or turn them off.
appliance. • Try using an outdoor antenna.
Noise is caused by motors,
• Keep the receiver away from noise
fluorescent lamps, or
sources.
lightning.
• Install an outdoor AM antenna.
15