Remote Control; Network - Yamaha BRX-610 Owner's Manual

TROUBLESHOOTING
■ Picture
Problem
Screen freezes and
operation buttons do
not work.
Video is not output
with the desired
resolution.
Wide-screen video
appears vertically
stretched, or black
bands appear at the
top and bottom of the
screen. Or 4:3 video
appears horizontally
stretched.
Square noise
(mosaic) appears on
the screen.
The playback screen
will be disturbed if
DVD video is
recorded to a VCR, or
played back through
a VCR.

Remote control

Problem
The remote control
does not work nor
function properly.

Network

Problem
Cannot connect to
the Internet.
48
En
Cause
This unit needs to be restarted.
Resolution is set incorrectly.
Aspect ratio of your TV is set incorrectly.
The disc is a copyright-protected disc.
Cause
The remote control is operated outside its
operation range.
The remote control sensor on this unit is
exposed to direct sunlight or lighting.
The battery is worn out.
There are obstacles between the sensor of
this unit and the remote control.
Cause
Incorrect cable connections.
The connected equipment is turned off.
Connections of the broadband router and/
or modem are incorrect.
The network setting is incorrect.
Remedy
Press , then restart playback.
Turn off the power and turn on the power again.
Press and hold on the front panel for around 5
seconds to restart this unit.
Set to the desired resolution.
Change the aspect ratio of your TV.
Blocks in images may be visible in scenes with rapid
movement due to the characteristics of digital image
compression technology.
This unit complies with analog copy protection.
Some discs contain a copy prohibiting signal. If you
try to play back such discs through a VCR, or record
to a VCR and play back the signal, the copy
protection will prevent normal playback.
Remedy
For information on the remote control operation
range, refer to "Using the remote control"
Change the lighting or orientation of this unit.
Replace the battery with new one.
Remove the obstacles.
Remedy
Connect the Network cable properly.
Turn on the connected equipment, such as the
broadband router or modem.
Connect the broadband router and/or modem
correctly.
Set the proper value(s) in the network setting. Refer
to "Network".
Page
—
—
—
38
38
—
—
Page
10
.
—
10
—
Page
15
—
—
37