Power On/Off - Hitachi CP-A221N User Manual

Power on/off

Power on/off
Turning on the power
Make sure that the power cord is firmly
1.
and correctly connected to the projector
and the outlet.
Make sure that the POWER indicator is
2.
steady orange (
Confirm that there is nothing that the lens
3.
door hits while opening. Press STANDBY/
ON button on the projector or the
remote control. The lens door opens, the
projection lamp lights up, and the POWER
indicator begins to blink green. When the
power is completely on, the indicator will
stop blinking and light in steady green
101).
(
WARNING ►Never look into the projection lens or mirror while
the projection lamp lights, since the projection lamp ray may cause
a trouble on your eyes.
►Be careful not to pinch your finger with the lens door, to prevent an injury.
►Do not place the projector vertically with the lens door open as
shown in the figure on the right. It could cause malfunction or injury.
Tabletop use must be setup with the designated optional accessories.
►Do not stand under the projector mounted on the wall or ceiling,
when its lens door is opening or closing. Moreover, do not look at the
mirror when the lens door is opening or closing.
►Never touch a lens door or mirror. If the mirror is broken, the
projected image will be distorted. Close the lens door, and contact
your dealer.
18
101).
STANDBY/ON button
POWER indicator
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH BLANK
MAGNIFY PAGE VOLUME
FREEZE UP
ON
DOWN
OFF
MY BUTTON
KEYSTONE MUTE
FOCUS D-ZOOM
POSITION MENU
ENTER
ESC RESET