Table of Contents
Advertisement
Hard Disk Write Protect [Disabled]
Disables or enables device write protection. This will be effective only if the device
is accessed through BIOS. Configuration option: [Disabled] [Enabled]
SATA Detect Time Out (Sec) [35]
Selects the time out value for detecting ATA/ATAPI devices.
Configuration options: [0] [5] [10] [15] [20] [25] [30] [35]
4.3.7
AHCI Configuration
This menu is the section for AHCI configuration. It appears only when you set the
item Configure SATA as from the sub-menu of SATA Configuration to [AHCI].
AHCI Settings
AHCI CD/DVD Boot Time out
AHCI Port1 [Not Detected]
AHCI Port2 [Not Detected]
AHCI Port3 [Not Detected]
AHCI Port4 [Not Detected]
AHCI Port5 [Not Detected]
AHCI Port6 [Not Detected]
AHCI CD/DVD Boot Time out [15]
Selects the boot time out value for SATA CD/DVD devices in AHCI mode.
Congifuration options: [0] [5] [10] [15] [20] [25] [30] [35]
AHCI Port1~6 [XXXX]
Displays the status of auto-detection of SATA devices.
AHCI Port1
Device
SATA Port1
SMART Monitoring
SATA Port1 [Auto]
Allows you to select the type of device connected to the system.
Configuration options: [Auto] [Not Installed]
SMART Monitoring [Enabled]
Allows you to set the Self-Monitoring, Analysis and Reporting Technology.
Configration options: [Disabled] [Enabled]
4-14
[15]
:Not Detected
[Auto]
[Enabled]
Some SATA CD/DVD in
AHCI mode need to
wait ready longer.
Select the type of
devices connected to
the system.
Chapter 4: BIOS setup
Advertisement
Table of Contents
