Lexmark T656 Setup Manual page 10

IPDS Printer and Host Setup Guide AS/400 and iSeries LAN Printing Using the Printer Standard Network Port or MarkNet Internal Print Server
Example CRTDEVPRT with parameters to change shown in
Remote network identifier............. RMTNETID
Workstation customizing object........ WSCST
Library............................
Authority............................. AUT
Activation Timer
Note 1: Setting the
the same printer. The writer does not time out while waiting on the printer to start a new job.
Step 4 Configure the Printer's Print Server TCP/IP Settings
To enable IPDS printing with a Standard Network port or a MarkNet internal LAN print server, several settings
must be verified. You can verify these settings from the printer control panel as shown below.
1 From a Ready state press the MENU button (printers) or touch
2 Use the navigation buttons or icons
3 Select Network/Ports.
TIp: To do this on printers, press the Select button
4 Now you will see a list of menus. Select the Standard Network menu.
5 Select Std Network Setup.
6 Select TCP/IP.
7 Use the navigation buttons or icons to scroll through the options. Check each of the following settings and
change them as needed to configure TCP/IP communication.
TCP/IP Settings
Parameter
Activate
(Printers: Must
cations. MFPs: not displayed.)
Address
(Address available from your network administrator)
Netmask
(Appropriate netmask for your network)
Gateway
(IP address of your IP gateway)
Enable DHCP
(On, if you use a DHCP server.)
(Off, if you set the IP address another way.)
to
to scroll to Network/Ports.
Value
On
be "On" to enable TCP/IP communi-
157.184.67.102
255.255.255.0
157.184.67.1
On or Off
*NOMAX
allows multiple writers or multiple hosts to use
; on MFPs just touch Network/Ports.
bold.
*NETATR
*NONE
*LIBCRTAUT
(Menus on MFPs).
10