Installing A Memory Module - HP Vectra XE320 Upgrade Manual

Hp vectra xe320, upgrade guide

Hide thumbs Also See for Vectra XE320:

Table of Contents

Installing a Memory Module

WARNING

For your safety, disconnect the power cord and all external cables.

Note

Only use HP memory modules provided for your PC model. The use of other memory modules is not supported. For information about

supported HP accessories, connect to www.hp.com/go/pcaccessories .

1 Switch off the PC, disconnect the power cord and remove the PC's side panel (refer to "Removing

and Replacing the Side Panel" on page 12).

2 Lay the PC on its side so you can access the system board.

3 Either remove the module you want to replace or locate an empty memory module socket.

4 Make sure that the socket's clips are open.

5 Align the grooves on the bottom of the module with the corresponding marks on the socket and push

it firmly into place. The clips close automatically.

Caution

You may damage the system board if you attempt to install a memory module the wrong way round.

6 Replace the PC's side panel (refer to "Removing and Replacing the Side Panel" on page 12).

7 Reconnect the power cord.

Upgrading and Replacing PC Hardware

Position of memory modules

Table of Contents