Ris Client Start - HP Vectra 486M - MI Setup Manual

5.3. RIS Client
Start
1. Switch on an RIS client (press F12 or any other key to
boot on the LAN). After a while, the message "Press
F12 for network service boot" will be displayed.
2. Press the F12. A blue welcome screen, in text mode,
will then appear. Press Enter.
A login screen requesting a "user name",
"password" for the username and a "domain
name" will appear next. Users can avoid filling in the
"domain name" box by entering <user
name>@<domain name> in the "user name" box.
Note that <domain name>\<user name> is NOT a
supported syntax in RIS, though it may work on legacy
PXE adapters.
èThe login entered should be one of those listed in the
domain controller and should have the appropriate
rights to register a computer in the domain. The
Windows 2000 administrator login is a common login
used.
èIf a "Windows did not find a driver for your
network hardware" message appears, users
should check the OEM driver install procedure.
èIf a Blue screen appears during the installation,
which begins with STOP 0xBB [...]. ([...] there is an
error with the network adapter). It is likely that the RIS
image was modified without using the RIS setup wizard
(build image creation step)
33