Figure 4.8 Removing The Ram From The Connectors; Installing The Optional Memory - Toshiba Satellite A660-BT3G25X Maintenance Manual

4. Spread out the two memory lock latches so that the upper memory module pops up.
Please follow the procedure as shown in Figure 4.8.
5. Pull the upper memory module up and out at an angle, using care to avoid touching the
connectors.
6. Repeat steps 4 and 5 to remove the lower memory module.

Installing the Optional Memory

Install the optional memory according to the following procedures after checking that the laptop
is turned off.
CAUTION: Install the optional memory after turning off the laptop. If this is violated, the
laptop or memory can be damaged.
1. Insert the lower memory module into the connector at an angle of 45 degrees.
2. Press down on the memory module so that it is secured with both memory lock latches.
3. Repeat steps 1 and 2 to install the upper memory module.
4. Reinstall the optional RAM door.
5. Secure the RAM door with one M2.5x5 screw.
After the laptop is turned on, check the hardware configuration in the Hardware Setup or
TESTUP program to make sure that the installed memory has been recognized by the system. If
it has not been recognized yet, check the connections.
Satellite A660/ProA660 Series Maintenance Manual

Figure 4.8 Removing the RAM from the connectors

4 Replacement Procedures
4-16