Seagate ST373455LC - Cheetah 73.4 GB Hard Drive Installation Manual page 40

38
Formatting the drive
The drive has been low level formatted at the factory. You do not
need to perform another low level format on this drive unless you
decide to perform certain diagnostics through the host adapter.
If you do decide to perform a low level format, do not abort the
format as this is likely to make the drive inoperable. Also, it is a
good idea to protect against power failure or other power inter-
ruptions during the format. Keep in mind that it may take up to
one hour per gigabyte to low level format the drive. Do not reboot
or otherwise disrupt the process.
Warning. Formatting a drive erases all user data. Be sure that
you understand this principle before formatting any
hard disc drive. It is not necessary to format a drive
that previously has been used to store data, unless
your intention is to erase all user data.
Note. Seagate is not responsible for lost user data.
1. Turn on DC power.
2. Boot the system from a system floppy disc or from a previ-
ously installed hard disc drive if there is one.
3. Format the disc drive. Barracuda 18LP disc drives are
designed to operate with a variety of operating systems.
Please refer to your system or SCSI controller manual for
information about formatting and setting up the drive. Some
quick desktop system notes are provided below.
Quick reference desktop system notes
Note. Refer to your system or utility manual for detailed instruc-
tions)
Barracuda 18LP Installation Guide, Rev. B