HP Rx2620-2 - Integrity - 0 MB RAM User Manual page 41

6. Click OK. The new VLAN is saved and the VLAN tab appears. The new VLAN you created
appears in the list on the VLAN tab.
7. Select from the following:
• Default VLAN Id: displays the VLAN ID to which all packets received without a VLAN
tag are sent. The default is the lowest VLAN ID defined for the team.
• Receive Path Validation VLAN Id: allows you to select the VLAN on which Receive
Path Validation Heartbeat Frames are transmitted. This control is enabled only when
Receive Path Validation Heartbeats are enabled on the Team Settings tab. The default
setting is the VLAN on the team with the lowest VLAN ID at the time the team is created.
• Active Path VLAN Id: allows you to select the VLAN ID used for Active Path Failover
validation. This control is enabled only if Active Path Failover is configured for the
team. The default setting is the VLAN on the team with the lowest VLAN ID at the time
the team is created.
• Fast Path VLAN Id: allows you to select the VLAN ID used for Fast Path Failover
monitoring. This control is enabled only if Fast Path Failover is configured for the team
and Cisco PVST+ is set as the Spanning Tree Protocol. The default setting is the VLAN
on the team with the lowest VLAN ID at the time the team is created.
• Router Path VLAN Id: allows you to select the VLAN ID used for Router Path Failover
monitoring. This control is enabled only if Router Path Failover is configured for the
team. Router Path Failover is not available for the following team type: Switch-assisted
Load Balancing with Fault Tolerance (SLB), and 802.3ad Dynamic with Fault Tolerance.
8. Make any VLAN and VLAN ID changes then click OK. The new settings are saved. The
NCU Main page appears. You must also click OK on the Main page to apply the changes.
Advanced redundancy types 41