Network Interface Operation; Status Lights; Network Connector - Epson Stylus Pro 4900 Network Manual

Network Interface Operation

Status lights

The status lights provide you with important information on the operation of
the network interface.
Indicates connection type
The light on the left indicates whether the network interface is connected to a
10Base-T (green) or 100Base-TX (orange) network.
The light on the right flashes when data is being transmitted or received.
If the light on the left is solid green and the light on the right is off, the printer
is not connected to the network.

Network connector

The RJ-45 connector is used to connect an Ethernet cable to a network. You
can use an Ethernet cable for both 10Base-T and 100Base-TX.
Caution:
c
You must use a Category-5 or higher shielded twisted-pair cable to connect the
network interface to a network.
10
Introduction
Indicates connection
type
RJ-45 connector
RJ-45 connector
Flashes when data is
Flashes when data
transmitted or received
is received