Setting Up The Refrigerator; Reversing The Door - Samsung RB31FDJNDBC User Manual

SETTINg up ThE REFRIgERATOR

Now that you have your new refrigerator installed
and in place, you are ready to set up and enjoy the
full features and functions of the appliance.
By completing the following steps, your refrigerator
should be fully operational.
If not, first check the power supply and electricity
source or try the troubleshooting section at the
back of this user guide.
If you have any further questions, contact your
Samsung Electronics service center.
1. Place the refrigerator in an appropriate location
with reasonable clearance between the wall
and the refrigerator.
Refer to installation instructions in this manual.
2. Once the refrigerator is plugged in, make sure
the interior light comes on when you open the
doors.
3. Set the temperature control to the coldest
temperature and wait for an hour.
The freezer should get slightly chilled and the
motor should run smoothly.
4. After powering the refrigerator, it will take a few
hours to reach the appropriate temperature.
Once the refrigerator temperature is sufficiently
cool, you can store food and drink in the
refrigerator.
After powering the refrigerator, the alarm
will sound. Press Freezer or Fridge button.
(Only for Coolselect zone funtion model )
Refer to on page 23 "Using the control
Panel".
18_ setting up
DA68-02833A(0.0)-EN.indd 18

REvERSINg ThE dOOR

(OpTIONAl)
Before you reverse the refrigerator door, make
sure to unplug the refrigerator. Samsung
recommends that reversing of the door opening
is only completed by Samsung approved Service
providers. This will be on a chargeable basis and at
the customers expense.
Any damage caused while attempting to
reverse the door opening is not covered
under the appliance manufactures
warranty.
Any repairs requested due to this
circumstance will be completed on
a chargeable basis at the customers
expense.
1. Before attempting to reverse the refrigerator
doors ensure that the refrigerator is
disconnected from the main electricity supply
and all food stuffs are emptied from inside the
appliance.
2. If the customer does not feel confident to follow
instruction in the user manual, a Samsung
qualified service engineer must be contacted to
carry out this change.
3. Do not plug in Refrigerator just after door
reverse finished process and wait for at least
one hour.
Required Tools
Not provided
Phillips Head Flat Head Driver
Driver (+) (-)
Not provided
8 mm Socket
Wrench Hinge Cover / Cap Space Door
(for bolts)
11 mm Wrench
(for hinge shaft)
Additional part
2012.12.18 11:31:3 AM