Table of Contents
Advertisement
3. Insert the battery pack.
4. Ensure the battery pack lock is moved into its locked position.
Starting the computer by password
To start up the computer with the user password, follow these steps:
1. Turn on the power as described in Chapter 3,
following message appears:
At this point, the hotkeys Fn + F1 to F9 do not work. They will function after
you enter the password.
2. Enter the password.
3. Press Enter.
If you enter the password incorrectly three times in a row, the computer
shuts off. In this case, you must turn the computer back on to retry
password entry.
Power-up modes
The computer has the following power-up modes:
■
Boot Mode: Computer shuts down without saving data. Always save
your work before you turn the computer off in boot mode.
■
Hibernation Mode: Data in memory is saved to the hard disk.
■
Standby Mode: Data is maintained in the computer's main memory.
Refer also to the sections
in Chapter 3,
User's Manual
Battery
Pack
Lock
Password=
Getting
Started.
Battery pack
Securing the battery pack
Turning on the power
Power and Power-Up Modes
Getting
Started. The
and
Turning off the power
6-12
Advertisement
Table of Contents
