HP Brio 80xx Online Manual page 60

3 If you are installing a 3.5-inch drive, use a star-shaped screwdriver to unscrew the two screws on either side of the front
plate and remove it.
4 If you are installing a 5.25-inch drive, remove the faceplate on the 5.25-inch bay by inserting a flathead screwdriver into
the slot, then push outward until the faceplate snaps off.
To avoid electric shock and harm to your eyes by laser light, do not open the laser module. The laser module should be
CD-ROM
serviced by service people only. Do not attempt to make any adjustment to the laser unit. Refer to the label on the
Warning
CD-ROM for power requirements and wavelength. This product is class 1 laser product.
3 Upgrading and Adding Accessories
Adding Accessories
60