Table of Contents
Advertisement
The recorded picture looks rough. Noise appears on the picture.
• Is the ISO sensitivity high or the shutter speed slow?
(ISO sensitivity is set to [,] when the camera is shipped. Therefore, when taking
pictures indoors etc. noise will appear.)
" Decrease the ISO sensitivity.
" Set [COLOR MODE] to [NATURAL].
" Take pictures in bright places.
• Has [HIGH SENS.] or [HI-SPEED BURST] in the Scene Mode been set? If so, the
resolution of the recorded picture decreases slightly because of high sensitivity
processing, but this is not a malfunction.
The brightness or the hue of the recorded picture is different from the actual
scene.
• If recording under fluorescent light, the brightness or the hue may change slightly when
the shutter speed becomes fast. This occurs due to the characteristics of fluorescent
light. It is not a malfunction.
While picture-taking or when the shutter button is pressed halfway, a reddish
vertical line (smear) appears on the LCD monitor or a part or the whole of the
screen has a tinge of red.
• This is a characteristic of CCDs, and it appears when the subject
has a bright part. Some unevenness may occur in the surrounding
areas, but this is not a malfunction.
It is recorded in motion pictures but is not recorded on still pictures.
• It is recommended that you take pictures while taking care not to
expose the screen to sunlight or any other source of strong light.
Motion picture recording stops in the middle.
• Depending on the type of the card, recording may stop in the middle.
" It is recommended to use a card with SD Speed Class
when recording motion pictures.
The SD Speed Class Rating is the speed standard for successive writes.
¼
" In the event that it stops even after using a "Class 6" card or higher, the data writing
speed has deteriorated so it is recommended to make a backup copy of the data and
then format the card in this unit (P31).
Others
(P85)
(P91)
- 139 -
with "Class 6" or higher
Advertisement
Table of Contents
