The System May Hang At The Boot Time When The Pci Irq Steering Is Changed From 11 (Default Value) To 9; 16-Bit Pc Cards Hot Plugged To The Dock Pc Card Slot Will Not Be Detected; Slot Of The Dock; After Warm Docking With An Ata Pc Card Already Installed In The Pc Card Slot Of The Dock - Lenovo ThinkPad i Series 1200 Installation Manual

2.5 The system may hang at the boot time when the PCI IRQ steering is changed
from 11 (default value) to 9
Models:
Issue:
Cause:
Resolution:
2.6

16-bit PC Cards hot plugged to the dock PC Card slot will not be detected

after warm docking with an ATA PC Card already installed in the PC Card slot
of the dock.
Models:
Issue:
Resolution
3

PC Cards and Device Support

3.1

PCMCIA Card Services yellow "!" with Code (1) - Not configured correctly

Models:
Issue:
ThinkPad 600X
When the user changes the value of PCI IRQ Steering to 9 from
11(default value) with the ThinkPad Utility in order to use the IDE
device in SelectaDockII/III, the system hangs at boot time.
Under investigation. This problem occurs only when Windows Me is
clean installed on the system It does not occur when Windows Me is
installed during an upgrade.
When the user encounters this problem, please change the value of
PCI IRQ Steering back to 11. If you still want to use the IDE device
in Docking, please change the assignment of IDE device by ThinkPad
Utility as below:
Primary Master Internal HDD
Primary Slave IDE devices in the Ultra Slim Bay (CD ROM or
other IDE devices)
Secondary Master/Slave
To configure above IDE configuration, follow the following step.
1. Open ThinkPad configuration by double-clicking the icon in
Systray.
2. Click DeviceBay -> Disable Warm Swap deices -> Apply -> OK
3. Reboot the system.
ThinkPad 390
When the ATA PC Card is already installed in the docking PC Card
slot, the system will not detect any 16-bit PC Card device when it's
hot plugged on the docking PC Card slot when the device driver is not
installed prior to Warm Dock.
Cold dock the system with 32-bit PC Card device in the dock PC Card
slot..
1. Shut down the System
2. Insert 32-bit PC Card device in the dock PC Card slot
3. Power on the System
4. The system should detect the new devices
5. Once the device driver is installed, the device will be detected
every time its cold/hot/warm docked.
All ThinkPad Models
When any PC Card device is installed, the OS detects it and installs
the PCMCIA Card Services. When PC Card device is hot plugged for
For IDE device in Docking