Ultraslimbay Device Swapping With Thinkpad Models 570 And 570E; Ultraslimbay Device Swapping With Thinkpad Models 600, 600E And 600X; Ultrabay 2000 Device Swapping With Thinkpad T20; Ultrabay 2000 Device And Ultrabase X2 Swapping With Thinkpad X20 - Lenovo ThinkPad i Series 1200 Installation Manual

The UltraBay FX slot holds the diskette and CD-ROM combination drive unit. You can
swap a diskette and CD-ROM (or diskette and DVD-ROM) combination drive with a
secondary IDE hard disk drive, or a secondary battery pack.
Swapping the UltraslimBay device under Windows Me is enabled only while the
computer is in Standby mode. In order to remove or insert a device designed for the
UltraslimBay, you must put the system into Standby. When the system is in Standby
mode, physically remove the device or insert another device.

UltraslimBay device swapping with ThinkPad models 570 and 570E:

ThinkPad 570 series support both hot and warm swapping (attach/detach) under the
Windows Me. To enable this feature, you must install the latest ThinkPad UltraBase
Utility Driver II.
On ThinkPad 570 series, the UltraslimBay slot is located in the UltraBase unit. To swap
a device from the UltraslimBay under Windows Me, you must first physically detach the
UltraBase from the system-unit. This is due to the mechanical design of the system.
To detach the computer from the UltraBase, press the eject-request button located on the
front side of he UltraBase unit. When pop-up window message appears, "System can be
removed from UltraBase safely" or the status indicator (green LED) near the eject-
request button is turned off, physically detach the system-unit from the UltraBase by the
eject levers. Once the device is removed, then swap in or out a device from the
UltraslimBay slot. Then attach the system unit back on.

UltraslimBay device swapping with ThinkPad models 600, 600E and 600X:

ThinkPad 600 series support only the warm swapping under the Windows Me. To enable
this feature, you must install the latest ThinkPad UltraBay Utility Driver.
Swapping the UltraslimBay device under Windows Me is enabled only while the
computer is in Standby mode. In order to remove or insert a device designed for the
UltraslimBay, you must put the system into Standby. When the system is in Standby
mode, physically remove the device or insert another device.

Ultrabay 2000 device swapping with ThinkPad T20:

ThinkPad T20 supports both hot and warm swapping of the Ultrabay 2000 devices under
Windows Me. To enable this feature, you must install the latest ThinkPad Fast-Swap
Feature Driver.
In order to remove an Ultrabay 2000 device, slide the bay-latch located next to the
Ultrabay 2000 device. When the bay status indicator is turned off or when the pop-up
window message appears, "Device can now be safely removed from the system", pop out
the handle and pull the handle to pull out the Ultrabay 2000 device. Remove or add
Ultrabay 2000 device.
Swapping the Ultrabay 2000 device is not supported while the system is in the
hibernation mode.
Swapping the Ultrabay 2000 device in the ThinkPad Dock is not supported.

Ultrabay 2000 device and UltraBase X2 swapping with ThinkPad X20: