Asus P3W-E User Manual page 28

3. HARDWARE SETUP
2. Attach the Heatsink
NOTE: If provided, you should follow the heatsink attachment instructions
that came with your heatsink or processor. The following steps are provided
only as a general guide and may not reflect those for your heatsink.
Using SECC fan with Pentium
Push the two lock arms one direction to
clamp the heatsink onto the processor
and the other direction to release.
Lock Arm
WARNING!
Make sure the heatsink is mounted tightly against the SECC2, SECC,
or SEPP; otherwise, the CPU will overheat. You may install an auxiliary fan to
provide adequate circulation across the processor's passive heatsink.
NOTE: The SEPP heatsink and fan (for Intel Celeron processors) is similar to
the SECC2 heatsink and fan except that the clamping design is different.
3. Insert the SECC2/SECC/SEPP
SECC with Pentium
a click (the picture in step 2 shows the locks in the outward position and inward in
the picture below).
With the heatsink facing the motherboard's chipset, push the SECC2, SECC, or
SEPP gently but firmly into the Slot 1 connector until it is fully inserted.
SECC
Push lock inward
28
®
II Using SECC2 fan with Pentium
Insert the four heatsink's pins through
the holes of the SECC2. Place the metal
clip on the ends of the pins and slide
until it locks into place.
Lock Arm
®
II only: Push the SECC's two locks inward until you hear
CPU fan cable to
fan connector
ASUS P3W-E User's Manual
Four Pins and metal clip
SECC2/SEPP
CPU fan cable to
fan connector
®
III