Bosch TDS4570GB Operating Instructions Manual page 18

Problem
The ironed
garment turns
dark and/or
sticks to the
soleplate.
The soleplate
turns brown.
The appliance
makes a
pumping
sound.
Loss of
pressure
during ironing.
Water spots
appear on the
garment during
ironing.
Water spots
appear on the
garment during
use of the
"PulseSteam"
function.
The hose gets
hot during use.
Water leakage
from the boiler.
The iron
does not stop
steaming after
placing it on
the pad (2).
If the above does not solve the problem, get in touch with an authorised technical
service.
You can download this manual from the local homepages of Bosch.
18
BOSC H
Possible causes
• The selected temperature is
too high and has damaged
the garment.
• This is a regular
consequence of continued
use over a long period of
time.
• Water is being pumped into
the steam tank.
• Water tank (1) is not
correctly inserted in the
housing.
• The sound will not stop.
Steam release button has
been activated for too long a
period of time, that is, it has
been pressed too frequently.
May be caused by steam
condensed on the ironing
board.
Water spots are caused by
steam condensation in the
hose when cooling down after
use.
This is normal. It is caused by
the steam passing through the
hose during steam ironing.
Filter (12) located at the side
of the appliance is loose.
"PulseSteam" function has
been activated by double
click.
Solution
• Select a suitable temperature
for the material being ironed
and clean the soleplate with a
damp cloth.
• Clean the soleplate with a
damp cloth.
• This is normal.
• Adjust the water tank to fit
correctly.
• If the sound will not stop, do
not use the steam generator
and contact an authorised
technical service centre.
Use the steam release button
at intervals. This improves the
ironing result as the textiles will
be steamed dried and ironed
properly.
Wipe the textile cover of the
ironing board, and iron any
water drops to dry them.
Water drops stop coming out
of the soleplate after using the
"PulseSteam" function for some
time.
Place the hose on the opposite
side so that you cannot touch
the hose during ironing.
Tighten up the filter.
Just press the trigger once
again and the iron will stop
steaming at once.
* Model dependent