Table of Contents
Advertisement
L ) BT1 (Battery)
If you want to erase CM OS...
1.Turn OFF the computer and unplug the power cord.
2.Remove the battery, wait for 30 second.
3.Re-install the battery.
4.Plug the power cord and turn ON the computer.
M) FD1 (Floppy Connector)
Please connect the floppy driv e ribbon cables to FDD. It supports 360K,720K,1.2M,1.44M and
2.88Mby tes floppy disk ty pes. The red stripe of the ribbon cable must be the same side w ith the
Pin1.
Connector Introduction
CAUTION
v Danger of explosion if battery is incorrectly
replaced.
v Replace only with the same or equivalent
type recommended by the manufacturer.
v Dispose of used batteries according to the
manufacturer' s instructions.
34
2
23
33
1
Advertisement
Table of Contents
