Table of Contents
Advertisement
Resetting disks to non-RAID
Resetting disks to non-RAID
Resetting disks to non-RAID
Resetting disks to non-RAID
Resetting disks to non-RAID
When you install an HDD that has been configured as part of another
RAID set, you may convert this broken RAID HDD to non-RAID mode. All
original data, however, will be lost.
To prevent damage to your system, you cannot select the HDD when
configuring a RAID set through the JMB363 utility.
To reset disks to non-RAID:
1.
In the main JMB363 RAID BIOS menu, highlight R e v e r t H D D t o
n o n - R A I D
n o n - R A I D using the up/down arrow key then press <Enter>.
n o n - R A I D
n o n - R A I D
n o n - R A I D
2.
Use the space bar to select the HDD that you want to reset to
non-RAD.
A selected HDD shows a
3.
A dialogue box appears to confirm the action. Press <Y> to confirm;
otherwise, press <N>.
Saving the settings and exiting setup
Saving the settings and exiting setup
Saving the settings and exiting setup
Saving the settings and exiting setup
Saving the settings and exiting setup
When you have finished, highlight S a v e & E x i t S e t u p
arrow key then press <Enter> to save the current RAID configuration and
exit the JMB363 RAID BOS utility.
A dialogue box appears to confirm the action. Press <Y> to confirm;
otherwise, press <N> to return to the JMB RAID BIOS menu.
A S U S N 4 L - V M D H
A S U S N 4 L - V M D H
A S U S N 4 L - V M D H
A S U S N 4 L - V M D H
A S U S N 4 L - V M D H
sign before it.
S a v e & E x i t S e t u p using the up/down
S a v e & E x i t S e t u p
S a v e & E x i t S e t u p
S a v e & E x i t S e t u p
R e v e r t H D D t o
R e v e r t H D D t o
R e v e r t H D D t o
R e v e r t H D D t o
5 - 4 1
5 - 4 1
5 - 4 1
5 - 4 1
5 - 4 1
Advertisement
Table of Contents
