Brushroll - Hoover UH70605 Owner's Manual

carbon filter : how to clean
(Available on select models only).
Your Carbon Filter is located on the underside of
the Filter made with HEPA media.
IMPORTANT
DO NOT RINSE OR WASH the Carbon Filter.
cyclonic filter assembly: how to clean
CAUTION
!
To reduce the risk of personal injury - unplug
vacuum before servicing. Do not use vacuum
without dirt cup or filters in place.
Remove dirt cup as described in Fig. 4.3.
4.9 Twist filter assembly (A) counter-clockwise.
Remove assembly from dirt cup.
4.10 Dirt and debris can be cleaned from the filter
assembly with the Dusting/ Upholstery Tool.
4.11 If further cleaning of the internal filter assembly
is required, turn dust skirt (B) counterclockwise to
remove.
4.12 Grab dirt cup shroud (C), pull straight off and
clean with dusting/upholstery tool.
After cleaning, replace dirt cup shroud (C) onto and
inside edge of filter assembly and align center lines
®
with Hoover emblem. Place skirt (B) onto shroud,
align (4) slots with (4) tabs, and turn clockwise to lock.
Place the filter assembly (4.9, A) on the dirt cup,
aligning (3) tabs on filter with (3) slots on dirt cup (B)
and twist it clockwise to secure into position.

brushroll

: how to clean
CAUTION
!
To reduce the risk of personal injury from moving
parts, unplug vacuum before servicing.
4.13 Turn vacuum over so bottom side is facing up.
Rotate red upper latch (A) counterclockwise.
4.14 Slide (2) lower latches (B) to the unlock position.
4.15 Pivot out bottom plate and remove any debris
and/or hair from brushroll.
4.16 Reposition bottom plate, aligning (2) screws
on nozzle with lower latches (4.14,B). Press
firmly on all front edges (4.16) of nozzle guard to
ensure that it is properly seated. Slide (2) lower
latches to lock in position, and rotate red upper
latch clockwise.
Actual model may vary from images shown.
what to buy: carbon filter
Carbon Filter may need to be replaced more
often to maintain optimal odor absorbing
effectiveness. Additional filter is available at
Hoover.com or call 1-800-944-9200. Ask for
Hoover
4.9
!
4.11
b
The Hoover
cup should all align on the front of the dirt cup if
assembled correctly.
Replace dirt cup as described in Fig. 4.5.
4.13
!
4.15
12
® Part No. 902404001.
4.10
A
4.12
C
®
emblem and center lines on the dirt
4.14
A
4.16
b