Asus MEL-B User Manual page 25

III. HARDWARE SETUP
7. Chassis, CPU , & Power Supply Fan Connectors (3-pin CHA_, CPU_, PWR_FAN)
These connectors support cooling fans of 500mA (6 Watts) or less. Orientate
the fans so that the heat sink fins allow airflow to go across the onboard heat
sink(s) instead of the expansion slots. Depending on the fan manufacturer, the
wiring and plug may be different. The red wire should be positive, while the
black should be ground. Connect the fan's plug to the board taking into consid-
eration the polarity of the this connector. NOTE: The "Rotation" signal is to
be used only by a specially designed fan with rotation signal.
WARNING! These connectors have power. Damage may occur to the mother-
board and/or the CPU fan if these connectors are incorrectly used.
MEL-B 12Volt Cooling Fan Power
8. Wake-On-LAN Connector (3-pin WOL_CON)
This connector connects to a LAN card with a Wake-On-LAN output, such as
the ASUS PCI-L101. The LAN card powers up the system when a wakeup
packet or signal is received from the network.
IMPORTANT: This feature requires that the WAKE On LAN Power Up Con-
trol is set to Enabled (see Power Management Setup under BIOS SETUP) and
that your system has an ATX power supply with at least 720mA +5V standby
power.
MEL-B Wake-On-LAN Connector
CPU Fan Power
GND
+12V
Rotation
Power Supply Fan
Chassis Fan Power
Ground
+5VSB
ASUS MEL-B User's Manual
PME
25