Asus MEL-B User Manual page 13

III. HARDWARE SETUP
Motherboard Settings
1) KBPWR
2) DIP6
3) DIP1,2,3
4) DIP7,8,9,10
Expansion Slots
1) DIMM1,2,3
2) Socket 370
3) SLOT1, SLOT2
4) PCI1,2,3
5) AGP
Connectors
1) KB-PS2KB
2) FLOPPY
3) PARALLEL
4) COM1, COM2
5) IDE1/IDE2
6) IDELED
7) CHA_, CPU_, PWR_FAN
8) WOL_CON
9) MSG.LED (PANEL)
10) SMI (PANEL)
11) PWR.SW (PANEL)
12) RESET (PANEL)
13) PWR.LED (PANEL)
14) KEYLOCK (PANEL)
15) SPEAKER (PANEL)
16) USB/MIR
17) IR
18) ATXPWR
19) PS/2
20) SBLINK
21) SMB
22) WOR
23) CHASIS
*
The onboard hardware monitor uses the address 290H-297H so legacy ISA cards
must not use this address; otherwise, conflicts will occur.
p. 14 Keyboard Power Up (Enable/Disable)
p. 15 VIO Setting
p. 16 CPU Bus Frequency
p. 16 CPU Core:Bus Frequency Multiple
p. 18 168-Pin DIMM Memory Support
p. 19 Central Processing Unit (CPU) Socket
p. 20 16-bit ISA Bus Expansion Slots
p. 20 32-bit PCI Bus Expansion Slots
p. 21 Accelerated Graphics Port
p. 22 Keyboard Port Connector (6-pin female)
p. 22 Floppy Disk Drive Connector (34-1 pins)
p. 23 Parallel Port Connector (25-pin female)
p. 23 Serial Port COM1 and COM2 Connectors (9-pin male)
p. 24 Primary/Secondary IDE Connectors (Two 40-1pins)
p. 24 IDE LED Activity Light (2 pins)
p. 25 Chassis, CPU, Power Supply Fan Connectors (Three 3-pin)
p. 25 Wake-On-LAN Header (3 pins)
p. 26 System Message LED (2 pins)
p. 26 SMI Switch Lead (2 pins)
p. 26 ATX Power & Soft-Off Switch Lead (2 pins)
p. 26 Reset Switch Lead (2 pins)
p. 26 System Power LED Lead (3-1 pins)
p. 26 Keyboard Lock Switch Lead (2 pins)
p. 26 System Warning Speaker Connector (4 pins)
P. 27 PS/2 Mouse/USB/IR Combo-Connector (18-1 pins)
p. 27 IrDA-Compliant Infrared Module Connector (5 pins)
p. 28 ATX Power Supply Connector (20 pins)
p. 28 AT Power Supply Connector (20 pins)
TM
p. 29 SB-Link
p. 29 SMBus Connector (5-1 pins)
p. 30 Wake-On-Ring Header (2 pins)
p. 30 Chassis Intrusion Sensor Lead (4-1 pins)
ASUS MEL-B User's Manual
*
Connector (6-1 pins)
13