Brother P-Touch PT-9700PC User Manual page 22

3 After the installation is completed and
the screen shown below is displayed,
click [Close].
The installation of printer driver is
completed.
Next, install the P-touch Editor 5.0.
4 Double click "P-touch Editor 5.0
Installer.mpkg".
The P-touch Editor 5.0 Installer starts up.
Follow the on-screen instructions.
5 When the installation is completed and
the message "Click Restart to finish
installing the software" is displayed, click
[Restart].
®
The Macintosh
The installation of software is completed.
is restarted.
6 After restarting the computer, connect
your printer to the computer by using the
USB cable, and then turn on the printer.
AC adapter jack
AC adapter
Note
●
If you are connecting the printer to
®
Macintosh via a USB hub, it may not be
detected correctly. If so, connect the printer
directly to the USB port on Macintosh
®
For Mac OS X 10.3.9 - 10.4.x
7
Double click the drive where Mac OS
is installed, and click in order of
"Applications" - "Utilities" - "Printer
Setup Utility".
®
For Mac OS X 10.5.x - 10.6
Click in order of "Apple menu" - "System
Preferences", and click "Print & Fax".
®
8 For Mac OS X 10.3.9 - 10.4.x
Click [Add] and choose USB at the top of
the screen.
Choose "PT-9700PC" from the list and
click [Add] again to add the printer to the
"Printer List".
®
For Mac OS X 10.5.x - 10.6
Choose "Brother PT-9700PC" from the list
and click [Add] /
the "Printer List" / "Print & Fax".
9 When the screen returns to "Printer List"
/ "Print & Fax" screen, check that "PT-
9700PC/Brother PT-9700PC" is added,
and close the "Printer List" / "Print &
Fax" screen.
Now you can use the printer.
USB port
USB cable
DC IN 24V
®
.
to add the printer to
®
X
21