Brother P-touch PT-9600 User Manual page 98

ERROR MESSAGE LIST
ERROR MESSAGE
LINE LIMIT!
XX LINES MAXIMUM
MEMORY FULL!
MIN 4 DIGITS!
NO FILES!
NO TAPE!
REPLACE BATTERIES!
(PT-9600 only)
86
CAUSE
● This message appears if you try
to print or use the Layout Pre-
view function when the number
of lines in the text is greater
than the maximum possible for
the installed tape.
● This message appears if you try
to print or use the Layout Pre-
view function when the number
of lines in the text is greater
than the maximum possible for
the installed tape. (Since the
number of lines possible
depends on the width of the
tape, the message that appears
depends on the tape width.)
16 LINES MAXIMUM (on 36 mm tape)
13 LINES MAXIMUM (on 24 mm tape)
10 LINES MAXIMUM (on 18 mm tape)
6 LINES MAXIMUM (on 12 mm tape)
4 LINES MAXIMUM (on 9 mm tape)
3 LINES MAXIMUM (on 6 mm tape)
● This message appears if you try
to store a text file after the maxi-
mum number of characters has
already been stored in the
memory.
● This message appears if less
than the minimum four digits
are entered as the barcode data.
● This message appears if no files
are stored in the memory when
you try to recall, delete or print
one.
● This message appears if no tape
cassette is installed when you
try to feed the tape, print or use
the Layout Preview function.
● This message appears when the
installed Ni-MH battery is about
to run out, or when the battery
has reached a high voltage.
SOLUTION
● Reduce the number of
lines or install a wider
tape.
● Delete an unwanted file to
make space for the new
one.
● Enter a minimum of four
digits before pressing n.
● Store a text file before try-
ing to recall, delete or
print one.
● Install a tape cassette and
try again.
● Replace the battery or use
the AC adaptor.