Turning On Your Pc For The First Time - HP A524x - Pavilion - 512 MB RAM User Manual

10
user's guide
To connect the Ethernet connector to the network:
1 Plug the network cable into the Ethernet connector (A) on the back of the PC.
WARNING: Do not plug the telephone service line cable or modem
cable into the Ethernet connector. Although the plug looks similar to
the plug on the Ethernet cable, they are not the same.
2 Plug the other end of the Ethernet cable into a 10BaseT or a 100BaseT port on
the network hub.
Hubs are devices that can connect PCs to a network.
NOTE:
3 With the PC turned on, check the lights next to the Ethernet connector for status:
•
ACTIVITY — Lit yellow during network data transfer activity
•
LINK — Lit green with valid network connection

turning on your pc for the first time

After you have completed the steps on the quick setup poster, you are ready to
turn on your PC.
1 Press the Power button on the monitor.
2 Press the On button (A) on the front of the PC (see the following figure).
3 Press the Power button on the speakers, if they are present.
4 Click an option to select your language (if applicable for your model). Click
OK and then confirm your selection by clicking Yes. Wait until the PC makes
preparations. (It may take up to 30 minutes to set up the language on the PC.)
5 Set up Microsoft ® Windows
6 Refer to the following section, "registering your pc," for information on
completing the registration process (select models only).
A
® by following the onscreen instructions.