Advertisement
Assembling the cymbal pad
1.
Using a tuning key (sold separately), loosen the stopper's key bolt. (See Figure 1.)
2.
Remove the wing nut, the two felt pads, and the bolt cover from the cymbal holder. (See Figure 2.)
3.
Slide the stopper onto the cymbal holder. (See Figure 3.)
If the key bolt was not sufficiently loosened in Step 1 above, it may not be possible to slide the
stopper onto the cymbal holder's shaft. In such a case, loosen the key bolt as much as possible
without removing it.
4.
Replace the bolt cover. (See Figure 3.)
When assembling the bolt cover, turn it until it stops.
Stopper
Key bolt
Tuning key
(sold separately)
Figure 1
5.
Secure the stopper in place. With the stopper making full contact with the bottom surface of the bolt
cover, tighten the stopper's key bolt using the tuning key. (See Figure 4.)
6.
Place one of the felt pads removed in Step 2 on the cymbal holder. (See Figure 5.)
7.
Assemble the pad on the cymbal holder. Lower the pad into place with the cymbal holder's shaft
passing through the hole at the center of the cup. When mounted, the stopper's pin should rest
inside the pad's smaller hole. (See Figure 5.)
If the stopper's pin is not positioned fully inside the smaller hole, the pad could become free of
the stopper when played. It is very important, therefore, to ensure that the stopper is secured as
described in Step 5 above.
8.
Place the second felt pad removed in Step 2 on the cymbal holder. (See Figure 5.)
Wing nut
Felt pads
Bolt cover
Cymbal
holder
Figure 2
Bolt cover
Full contact
Stopper
Figure 4
PCY90AT
Bolt cover
Stopper
Cymbal
holder
Figure 3
Owner's Manual
7
Advertisement
