Table of Contents
Advertisement
Step 3:
If Setup correctly recognizes the driver in the floppy disk, a controller menu similar to Figure 20 below
will appear. Use the ARROW keys to select Intel(R) 82801 GR/GH SATA RAID Controller (Desktop
ICH7R/DH)* and press ENTER. Then it will begin to load the SATA driver from the floppy disk.
Windows Setup
You have chosen to configure a SCSI Adapter for use with Windows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
ENTER=Select F3=Exit
If a message appears saying one or some file(s) cannot be found, please check the floppy
disk or copy the correct SATA driver again from the motherboard driver CD.
Step 4:
When the screen as shown below appears, press ENTER to continue the SATA driver installation from
the floppy disk. The driver installation will be finished in about one minute.
Windows Setup
S=Specify Additional Device Enter=Continue F3=Exit
"*" If you wish to install 64-bit Windows Operating System, select Intel(R) 82801 GR/GH SATA AHCI
Controller (Desktop ICH7R/DH).
SATA Hard Drives Configurations (Intel ICH7R)
Intel(R) 82801 GR/GH SATA RAID Controller (Desktop ICH7R/DH)
Intel(R) 82801 GR/GH SATA AHCI Controller (Desktop ICH7R/DH)
Intel(R) 82801 FR SATA RAID Controller (Desktop ICH6R)
Intel(R) 82801 FR SATA AHCI Controller (Desktop ICH6R)
Setup will load support for the following mass storage device(s):
Intel(R) 82801 GR/GH SATA RAID Controller (Desktop ICH7R/DH)
* To specify additional SCSI adapters, CD-ROM drives, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.
Figure 17
Figure 18
- 12 -
Advertisement
Table of Contents
