Assembly; Preparation Before Assembling - Yamaha Clavinova CVP-601 Owner's Manual

Assembly

Preparation Before Assembling

CAUTION
• Assemble the stand on a flat floor with ample space.
• Be careful not to confuse parts, and be sure to install all parts in
the correct direction. Please assemble in accordance with the
sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated below. Use of
incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing assembly of
each unit.
• To disassemble, reverse the assembly sequence given below.
Have a Phillips-head (+) screwdriver of the appropriate
size ready.
Remove foamed styrol pads from the package, position
them on the floor, then place A on top of them. Position
the pads so that they will not hide the connectors on the
bottom of A.
Remove all parts from the box. Confirm that all parts shown
in the illustration are provided.
Main Unit
Back panel
Pedal Box Bundled pedal cord inside
Side panel (left)
D
98 CVP-601 Owner's Manual
A
Foamed styrol pads
B
C
Side panel(right)
E
Assembly parts
6 x 20 mm long screws x 4
4 x 20 mm tapping screws x 4
6 x 16 mm short screws x 6
4 x 12 mm thin screws x 2
Holder set
For details on how to set the holders, refer to page 94.
Assembly
1
Attach C to D and E.
Untie and straighten out the bundled pedal cord.
Do not discard the vinyl tie. You will need it later
in step 5.
Attach D and E to C by tightening four long
screws (6 x 20 mm).
D
C C
Cord holders x 2
Power cord
Headphone hanger
Headphone hanger
4 x 10 mm thin screws x 2
E E