Table of Contents
Advertisement
3.
AMD
SB850 Serial ATA Serial ATA 6.0 Gb/s connectors (7-pin SATA 1-6)
®
These connectors are for the Serial ATA 6.0 Gb/s signal cables for Serial ATA hard disk
drives and optical disc drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID 1, RAID 5,
or RAID 10 configuration through the onboard AMD
• These connectors are set to IDE mode by default. In IDE mode, you can connect Serial
ATA boot/data hard disk drives to these connectors. If you intend to create a Serial ATA
RAID set using these connectors, set the SATA Port item in the BIOS to [RAID]. See
section 2.4.2 Storage Configuration for details.
• You must install Windows
ATA hard disk drives. The Serial ATA RAID feature is available only if you are using
Windows
• When using hot-plug and NCQ, set the SATA Port item in the BIOS to [AHCI]. See
section 2.4.2 Storage Configuration for details.
Chapter 1: Product introduction
XP Service Pack 2 or later version before using Serial
®
XP SP2 or later version.
®
SB850 controller.
®
1-27
Hide quick links:
Advertisement
Table of Contents
